This is very cool... just don't reach your hand in the liquid.
That would ruin your day.
| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Brass Identification Plates http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10102&t=9934 |
Page 1 of 1 |
| Author: | Jocafa [ Thu Dec 21, 2006 7:06 am ] |
| Post subject: | |
Hey gang, I just ran across this article via Make Magazine's blog: Electrolytic Etching of Brass I think that making little business card sized plates for branding and identification would look very nice if done properly. I'm not sure how it would affect sound if you put it where a paper slip would normally go. Anyway, it looks like it could be a fun, stylish addition worth playing with, and not terribly difficult. |
|
| Author: | Michael Dale Payne [ Thu Dec 21, 2006 7:17 am ] |
| Post subject: | |
Put it on your case. I do this with each commission I send out. Not electroetch but engraved brass plates stating: "One of a Kind, Hand-Crafted guitar Built excusivly for client name" I would worry a brass plate glued to the inside of a guitar would just ad weight and eventually come unglued |
|
| Author: | Andy Zimmerman [ Thu Dec 21, 2006 7:49 am ] |
| Post subject: | |
I do the same. Brass plates with the name of the owner on it for the case. I like this technique though. |
|
| Author: | Brock Poling [ Thu Dec 21, 2006 8:59 am ] |
| Post subject: | |
This is very cool... just don't reach your hand in the liquid. That would ruin your day.
|
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|