| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| make a slide http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10104&t=31125 |
Page 1 of 1 |
| Author: | mikemcnerney [ Tue Feb 15, 2011 11:47 am ] |
| Post subject: | make a slide |
I'm going to try learning dobro again & the slide i have is over 3" long & very heavey. So at the local store yesterday I saw some nice wooden handled ones. How would you approach making the metal part? MM |
|
| Author: | windsurfer [ Tue Feb 15, 2011 2:08 pm ] |
| Post subject: | Re: make a slide |
cut the round part from Stainless steel of brass rod. (brass is a lot easier to cut) brass is normally chrome plated, but the chrome wears out quickly. another approach would be to polish up a deep socket and glue the handle to it. you can also cut from glass rod, or anything else that is round and hard that you can polish -even copper pipe tone is very dependant on the weight. -jd |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|