Official Luthiers Forum!
http://w-ww.luthiersforum.com/forum/

Not Guitars but :)
http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10106&t=30417		 Page 1 of 1
Author:  Mike Kroening [ Tue Dec 21, 2010 6:42 pm ]
Post subject:  Not Guitars but :)
This is something I made the past 2 days for a sick little girl on my cnc from Santa. bliss

Mike

Image
Author:  turmite [ Tue Dec 21, 2010 6:59 pm ]
Post subject:  Re: Not Guitars but :)
Vetric or Artcam?
Author:  Mike Kroening [ Tue Dec 21, 2010 7:12 pm ]
Post subject:  Re: Not Guitars but :)
I went over to a friends who just got Aspire 3.0 Worked this up. Very nice program. Has some nice features. Still not Artcam in many ways but catching up quickly.
Mike
Author:  cyborgcnc [ Tue Dec 21, 2010 9:36 pm ]
Post subject:  Re: Not Guitars but :)
Mike that looks awesome!!

Is it oak?

Was that all done with a V-bit?
Author:  Mike Kroening [ Tue Dec 21, 2010 10:20 pm ]
Post subject:  Re: Not Guitars but :)
Thanks

No it is Hard maple(added amber tint in the prewash shellac, before the lacquer). I used a 1/4" ball for rough out 0.050 allowance. 1/16th" tapered ball for finish(precise bits), a 1/2" 90* V for the text. 1/4" endmill for the oval cutout from the back.
The oval mirror is a 5x7. My speeds and feeds were 150IPM feed and 40IPM plunge for all except the cutout on the back. Where I used 100IPM Feed and 20 Plunge at 0.125cut depths. On the 1/16th I stepped over at 0.005 for an almost no sand finish.

:)

Mike
Author:  npalen [ Wed Dec 22, 2010 10:52 am ]
Post subject:  Re: Not Guitars but :)
Awesome work, Mike!!!!
Author:  Mitch Cain [ Fri Dec 24, 2010 8:27 am ]
Post subject:  Re: Not Guitars but :)
Great looking stuff,Mike [:Y:]
Author:  Mike Kroening [ Fri Dec 24, 2010 10:13 am ]
Post subject:  Re: Not Guitars but :)
npalen wrote:
Awesome work, Mike!!!!

Mitch Cain wrote:
Great looking stuff,Mike [:Y:]

Thanks Guys.

Mike
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/