| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Rhino Question: Pattern inside a guitar that's always X" in? http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10106&t=30795 |
Page 1 of 1 |
| Author: | turmite [ Fri Jan 21, 2011 4:16 pm ] |
| Post subject: | Re: Rhino Question: Pattern inside a guitar that's always X" in? |
Chris have you tried offset surface? Make your sides and top or back seperate, then do an offset surface on whichever surfaces you want, hide your originals and do fillet surfaces if you want the inside radiused. Mike |
|
| Author: | Andy Birko [ Fri Jan 21, 2011 4:59 pm ] |
| Post subject: | Re: Rhino Question: Pattern inside a guitar that's always X" in? |
I don't know Rhino well but I know that in SolidWorks there's a button that "hollows" a part out, you just enter the wall thickness you want. Look in the manual and see if you can find it. |
|
| Author: | Andy Birko [ Fri Jan 21, 2011 6:09 pm ] |
| Post subject: | Re: Rhino Question: Pattern inside a guitar that's always X" in? |
Offset Curve is the feature you're looking for. Select the curve you want offset, pick an amount and a direction and Bob's your uncle. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|