Those that use Solidworks here, check this out!
http://www.npowersoftware.com/NewPowerS ... rview.html
Now this HAS potential!
| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Power Surfacing for SolidWorks..... http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10106&t=39615 |
Page 1 of 1 |
| Author: | cyborgcnc [ Tue Mar 05, 2013 11:23 pm ] |
| Post subject: | Power Surfacing for SolidWorks..... |
Those that use Solidworks here, check this out! http://www.npowersoftware.com/NewPowerS ... rview.html Now this HAS potential!
|
|
| Author: | mcentric [ Thu Mar 28, 2013 5:24 am ] |
| Post subject: | Re: Power Surfacing for SolidWorks..... |
cyborgcnc wrote: Those that use Solidworks here, check this out! http://www.npowersoftware.com/NewPowerS ... rview.html Now this HAS potential! Absolutely! They picked up the ball after Autodesk killed any chance of tSpline for SW. To be honest I think it's a lot better already than tSplines for Rhino ever was. I got a chance to sit down with PowerSurfacing and the developers at Integrityware for a product integration session at SolidWorks World in January. They were really attentive to us, the users, ideas and wishes, and I'm sure the product is just going to get better and better. Mikael |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|