Official Luthiers Forum!
http://w-ww.luthiersforum.com/forum/

Need to subcontract some 3D drawings...
http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10106&t=41781		 Page 1 of 1
Author:  Alain Moisan [ Mon Oct 28, 2013 3:55 pm ]
Post subject:  Need to subcontract some 3D drawings...
Hi guys,

I need a simple 3D drawing, and since I don't have the time to learn any 3D software, I will subcontract it to someone. So I thought I'd ask here first.

The drawing is for an article I'm about to write about helical shaped fretboard (or when the taper is not the same on both sides of the fretboard). I need an exaggerated view of such a fretboard, in 3D.

I have sketched in Paint a draft of what I want:

Attachment:
Helical fretboard draft.JPG


So the same thing as in the sketch, only with frets, and possible looking a bit cooler than my Paint drawing...;)

Anyone interested?

Thanks!
Author:  Rodger Knox [ Mon Oct 28, 2013 4:34 pm ]
Post subject:  Re: Need to subcontract some 3D drawings...
Do you need an actual 3D model, or would an isometric rendering (as you've shown in your sketch) be adequate?
A 3D model would be compatable with CNC manufacturing, and could not be exaggerated.
The isometric rendering is just a picture, and can be exaggerated.
I'd be willing and able to do either one, but if you want a 3D model I'd need to confirm the software I use is compatable with your CNC.
Author:  Alain Moisan [ Mon Oct 28, 2013 4:57 pm ]
Post subject:  Re: Need to subcontract some 3D drawings...
Hi Rodger, and thankls for replying that quickly!

What I actually need is probably several isometric extractions of a 3D model. At the end, I just need a few isometric views, but I'm not sure what point of view will be the best. And since I will not run this in any CNC whatsoever, you can exagerate the 3D nodel without any issue.
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/