| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| How to make a Pyramid Bridge http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10117&t=17431 |
Page 1 of 1 |
| Author: | Allen McFarlen [ Sun Jun 01, 2008 2:45 am ] |
| Post subject: | How to make a Pyramid Bridge |
Bob Connor recently sent me a beautiful Brazilian Rosewood pyramid bridge to use on my current project that's a size 5 terz guitar. I wanted to be able to replicate this bridge with local hardwoods so set about figuring out how to do it without a CNC mill, so here's my take on how to go about it. |
|
| Author: | Don Williams [ Sun Jun 01, 2008 7:10 am ] |
| Post subject: | Re: How to make a Pyramid Bridge |
Frank Ford shows an even easier way on his website, frets.com. The one critical tool was one of those 1" vertical belt sanders. Nice tool... |
|
| Author: | Allen McFarlen [ Sun Jun 01, 2008 2:47 pm ] |
| Post subject: | Re: How to make a Pyramid Bridge |
I had a look at the way that Frank built the ivory one but I couldn't figure out how to get the little step around the bottom of the pyramid that I was trying to replicate. I'll try Frank's method for the next one and see how the two methods compare. I'll add that once I came down with a way to accurately size the pyramid, the whole process goes very quickly. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|