Official Luthiers Forum!
http://w-ww.luthiersforum.com/forum/

Routing Jig for 2-Way Martin Truss Rod Ends
http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10117&t=42537		 Page 1 of 1
Author:  theguitarwhisperer [ Fri Jan 24, 2014 11:50 pm ]
Post subject:  Re: Routing Jig for 2-Way Martin Truss Rod Ends
But the bottom is flat.
I use a 1/4 inch round bit and an edge guide for the main route, then switch to a 3/8th's round bit for the last part. If I keep the edge guide the same, the larger bit is exactly centered to the first route already and I can route the last part the correct depth by setting the depth stop.
Fits perfectly and there's no square edge slot stress riser.
Edge guide, router, and 2 bits.
Just measure a little more carefully than I did, this one was a little sloppy I admit...
:D
Author:  theguitarwhisperer [ Fri Jan 24, 2014 11:56 pm ]
Post subject:  Re: Routing Jig for 2-Way Martin Truss Rod Ends
double
Author:  dzsmith [ Sun Feb 02, 2014 10:24 am ]
Post subject:  Re: Routing Jig for 2-Way Martin Truss Rod Ends
Great idea Todd!
I've been using Martin style rods on electrics and never thought of using a template.
Dan
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/