Official Luthiers Forum!
http://w-ww.luthiersforum.com/forum/

Corian for a Router table top ?
http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10117&t=48610		 Page 1 of 1
Author:  SG Lou [ Tue Nov 29, 2016 10:30 am ]
Post subject:  Corian for a Router table top ?
Hi Guys,
New to the forum, intro is here: viewtopic.php?f=10101&t=48602

Has anyone ever made or used Corian as top for a router table?
I can get my hands on a 2' x 3' piece for next to nothing and I really need to upgrade my current router table.
Author:  Bob Orr [ Tue Nov 29, 2016 10:43 am ]
Post subject:  Re: Corian for a Router table top ?
Have not used it but given how stable it is, and you can rout it, I think it would make a great table top.

Bob
Author:  murrmac [ Mon Dec 12, 2016 3:35 pm ]
Post subject:  Re: Corian for a Router table top ?
It will make a really nice top, but don't overestimate its stability ... I assume you will be using the standard 12mm thick stuff ...I would reinforce as much of it as possible with 3/4" plywood glued on with contact cement, just leaving enough for the aperture. 2'x3' supported only at the perimeter will sag over time.
Author:  Clay S. [ Tue Dec 13, 2016 12:35 pm ]
Post subject:  Re: Corian for a Router table top ?
I used corian for a router table top (still have it around somewhere) I made the plate the router mounted to out of corian as well. I made it large enough to lift out with the router attached. No real problems with it. Fences had to be clamped rather than screwed down. I did away with the router table to save space and mounted a router base to the aux. table of my tablesaw.
Author:  SG Lou [ Tue Dec 13, 2016 1:04 pm ]
Post subject:  Re: Corian for a Router table top ?
Thanks for the tips and heads up Guys [:Y:]
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/