| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| WEre to find Bar fret material ak Martin http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10122&t=24554 |
Page 1 of 1 |
| Author: | the Padma [ Wed Nov 11, 2009 9:33 pm ] |
| Post subject: | WEre to find Bar fret material ak Martin |
. Anybody know were to find the old bar freting steel that Martin use to use once upon a time long ago, way back when? Or the type of steel they were made from? thanks the Padma |
|
| Author: | MRS [ Mon Nov 16, 2009 2:24 am ] |
| Post subject: | Re: WEre to find Bar fret material ak Martin |
I believe you can purchase them through martin still. I don't think they list them on their site. You have to contact them. They were nickel too. Here is another place that sells them. Expensive though..Mike http://www.frettedstrings.com/shop/BarFretWire.html |
|
| Author: | the Padma [ Mon Nov 16, 2009 5:52 pm ] |
| Post subject: | Re: WEre to find Bar fret material ak Martin |
MRS wrote: I believe you can purchase them through martin still. I don't think they list them on their site. You have to contact them. They were nickel too. Here is another place that sells them. Expensive though..Mike http://www.frettedstrings.com/shop/BarFretWire.html Thank you Michael, May your teeth never fall out. blessings the Padma |
|
| Author: | sprouseod [ Fri Nov 27, 2009 10:12 am ] |
| Post subject: | Re: WEre to find Bar fret material ak Martin |
http://www.martinguitar.com/1833/catalo ... ar%20Parts |
|
| Author: | MRS [ Sat Dec 12, 2009 6:26 pm ] |
| Post subject: | Re: WEre to find Bar fret material ak Martin |
sprouseod wrote: http://www.martinguitar.com/1833/catalog.php?cat=Kits%20Parts%20%26%20Tools&subcat=Guitar%20Parts Can you pinpoint exactly where the bar fret wire is? |
|
| Author: | Jeff Highland [ Sun Dec 27, 2009 8:36 pm ] |
| Post subject: | Re: WEre to find Bar fret material ak Martin |
As I recall, Martin sold off it's stock of bar fretwire to a third party (TJ Thompson?) a few years ago and he is the only ready source now It was nickel based not steel |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|