| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| thickness sides opn a joine http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10122&t=39359 |
Page 1 of 1 |
| Author: | crazicarl [ Fri Feb 15, 2013 11:37 am ] |
| Post subject: | thickness sides opn a joine |
Had a crazy idea and was wondering if anyone had tried it. Do you think you could glue the ends of your sides to a sacrificial board and run it through a joined? Then just release the glue with heat or cut them apart? Anyone? |
|
| Author: | Quine [ Fri Feb 15, 2013 1:35 pm ] |
| Post subject: | Re: thickness sides opn a joine |
I've seen it done with a thickness planer. I guess it could be done with a joiner, but I would try a scrap first |
|
| Author: | Jim Watts [ Fri Feb 15, 2013 2:05 pm ] |
| Post subject: | Re: thickness sides opn a joine |
What problem are you trying to solve? |
|
| Author: | crazicarl [ Fri Feb 15, 2013 5:53 pm ] |
| Post subject: | Re: thickness sides opn a joine |
I'm working walnut that is resistant to my hand planing efforts and I only get to work a bit at a time. Just thought it might speed up the process. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|