Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/
Duplicarving service? http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10123&t=24974	Page 1 of 1

---

Author:	Ken McKay [ Wed Dec 09, 2009 3:19 pm ]
Post subject:	Duplicarving service?
I need some molds copied for making laminated guitar plates. Does anyone know where I can find someone to duplicarve my mold in wood?

---

Author:	turmite [ Thu Dec 10, 2009 12:38 am ]
Post subject:	Re: Duplicarving service?
Ken do a google for gunstock or furniture duplication. Those fields would be a good place to look. At one time I owned three different duplicators at the same time....now it is cnc. You don't by chance have a 3d model of the guitar top do you? Mike

---

Author:	Ken McKay [ Thu Dec 10, 2009 3:57 pm ]
Post subject:	Re: Duplicarving service?
Termite, no I don't have a 3D model. It would be nice though.

---

Author:	Mark A Thorpe [ Fri Dec 11, 2009 6:57 am ]
Post subject:	Re: Duplicarving service?
What size is the top? I have a machine that can scan the top, but it is limited as to the size it can scan.

---

Author:	Ken McKay [ Fri Dec 11, 2009 3:50 pm ]
Post subject:	Re: Duplicarving service?
Hi Mark, that would be great! The plate mold is 22 inches long by about 20 wide.

---

Author:	Mark A Thorpe [ Fri Dec 11, 2009 6:09 pm ]
Post subject:	Re: Duplicarving service?
The length isn't the problem, but the max width that it can scan is 14.75". I made my radius dishes with the machine, but I had to do it in two pieces. Are you trying to make a mold similar to a radius dish? If it can be scanned as a half, and then put together, then I have the capabilities.

---

Author:	Ken McKay [ Fri Dec 11, 2009 8:44 pm ]
Post subject:	Re: Duplicarving service?
It is a symmetrical mold and the arching is within 14.75", actually probably goes flat at about 13 inch. It is for ES 335 style double cutaway guitars.

---

Page 1 of 1	All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/