Official Luthiers Forum!
http://w-ww.luthiersforum.com/forum/

PRS Custom 24 measurements
http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10123&t=28023		 Page 1 of 1
Author:  jimmysux [ Wed Jun 30, 2010 1:50 pm ]
Post subject:  PRS Custom 24 measurements
Been taking measurements of my CU 24 with a trem and thought I would share, just to, and just to see if anyone thought I was off on anything.

End Of Headstock To Nut = 6 1/8"
From Nut To Bridge Saddle = 25 1/2"
Width Of Body At Largest Point = 13"
Depth Of Neck Joint = 1 5/16"
Length Of Body At Longest Point = 17 3/4"
Depth Of Neck without fingerboard = 3/4" (mine is a wide thin)
Body Thickness = 1 7/8" (Mahogany Back is 1 1/8" leaving maple cap thickness at 3/4")
Neck Angle = 3.5 degrees
Headstock Angle = 13 degrees
Author:  jimmysux [ Wed Jun 30, 2010 2:18 pm ]
Post subject:  Re: PRS Custom 24 measurements
oops_sign 25" on that scale length
Author:  Gabby Losch [ Wed Jun 30, 2010 3:32 pm ]
Post subject:  Re: PRS Custom 24 measurements
Very timely post for me. I've been running back and forth from the garage to measure things on my PRS Custom 24 for reference during my current build. Nice to have everything written out in one place. Thanks!
Author:  jimmysux [ Sat Jul 03, 2010 10:51 am ]
Post subject:  Re: PRS Custom 24 measurements
Mine is a 2008 custom 24. Clocked in right at 3.5 for me.
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/