| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Binding cutter for carve top electrics http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10123&t=28793 |
Page 1 of 1 |
| Author: | Mustang_jt [ Fri Aug 27, 2010 8:03 am ] |
| Post subject: | Re: Binding cutter for carve top electrics |
Thats a nice little set up. this is one of the many reasons I went to an overarm pin router. I haven't rouched my router table since I got it. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|