Official Luthiers Forum!
http://w-ww.luthiersforum.com/forum/

universal
http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10123&t=29227		 Page 1 of 1
Author:  skankstro [ Sat Sep 25, 2010 7:40 pm ]
Post subject:  universal
does anybody know the dimensions of the fender universal pickup route? if you don't know its this thing fender did or does that instead of routing the coils individually there's a single route for the entire package basically a rectangle so that all that's needed to change the pickups is a switch of the pickguard.
Author:  skankstro [ Sat Sep 25, 2010 10:46 pm ]
Post subject:  Re: universal
anyone?
Author:  alan stassforth [ Sat Sep 25, 2010 11:56 pm ]
Post subject:  Re: universal
If I remember right, they routed way bigger than the pickups, with a route for the wiring.
Why don't you figure out what you need routed out, make a jig, and do it.
There is only so much you can ask here.
Lay it out on paper, make jigs, and do it on you own.
Best way to learn.
Make some mistakes.
I'm still making them.
Screw the universal fender routing deal.
Make your own.
It will work fine.
Author:  skankstro [ Sun Sep 26, 2010 12:04 am ]
Post subject:  Re: universal
yea i know but i just wanna learn before hand. i will though
Author:  peters instruments [ Sun Sep 26, 2010 12:34 am ]
Post subject:  Re: universal
i agree it will be hard to screw up, as long as its bigger than your pickups and smaller than pickguard its not gonna matter much just draw up what you need.
Author:  skankstro [ Sun Sep 26, 2010 9:20 am ]
Post subject:  Re: universal
thanks guys! that helps alot! [:Y:] [clap] :D
Author:  alan stassforth [ Sun Sep 26, 2010 10:17 am ]
Post subject:  Re: universal
Hey, go to Guitar Center and ask if you can take a Strat apart and measure it.
ha!
Just kidding.
There must be plans available with those dimensions on them.
Good luck.
Author:  skankstro [ Sun Sep 26, 2010 10:54 am ]
Post subject:  Re: universal
alan stassforth wrote:
Hey, go to Guitar Center and ask if you can take a Strat apart and measure it.
ha!
Just kidding.
There must be plans available with those dimensions on them.
Good luck.


its not a strat style, or tele its custom but i know i will have to cut the pickguard at the cutaway or make my own pickguard

anyways i have a few plans from stew but none would work for me
Author:  Brett L Faust [ Sun Sep 26, 2010 4:00 pm ]
Post subject:  Re: universal
Just remember to keep a trem and the feet of a humbucker in mind as you lay out your jig.
Have fun.
Author:  skankstro [ Sun Sep 26, 2010 4:11 pm ]
Post subject:  Re: universal
Brett L Faust wrote:
Just remember to keep a trem and the feet of a humbucker in mind as you lay out your jig.
Have fun.

its ganna use a wraparound fixed bridge and the feet of the humbuckers are in mind
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/