| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Neck Problems http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10123&t=29635 |
Page 1 of 1 |
| Author: | Hoblum [ Sun Oct 24, 2010 6:04 pm ] |
| Post subject: | Neck Problems |
I am having problems getting a straight cut on my neck. I think I might just be impatient, if this is the case I will need to correct this, but if anyone knows any good tips or trick to use when trying to cut a solid neck blank into an angled neck please let me know. All of the books I have read don't give me any hints. I don't have a workbench, which is probably my first problem since I don't have a table vise but I am trying to make do without. |
|
| Author: | Rusty [ Sun Oct 24, 2010 8:31 pm ] |
| Post subject: | Re: Neck Problems |
What kind of cutting tools do you have? How did you attempt this last cut? |
|
| Author: | alan stassforth [ Sun Oct 24, 2010 9:21 pm ] |
| Post subject: | Re: Neck Problems |
Looks like an attempt at a peghead scarf joint. Try using a razor knife to cut your lines, then patienly work to the lines with a rasp, then a sanding block. Be very careful though. |
|
| Author: | Rob Warren [ Mon Oct 25, 2010 3:09 am ] |
| Post subject: | Re: Neck Problems |
How about getting it close with a saw, and then truing it up with a plane?? Stack the short piece on top of the long piece so the angle lines up and go to town. Check frequently with a straight edge. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|