I finished up my first carved top body today, i think it came out fairly well. I used the topigraphical routing and sanding technique. The guitar is getting close.
| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| My First Carved Top http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10123&t=32824 |
Page 1 of 1 |
| Author: | Ommadon [ Sun Jul 10, 2011 9:35 pm ] |
| Post subject: | My First Carved Top |
I finished up my first carved top body today, i think it came out fairly well. I used the topigraphical routing and sanding technique. The guitar is getting close.
|
|
| Author: | cactus [ Sun Jul 10, 2011 10:53 pm ] |
| Post subject: | Re: My First Carved Top |
What a pleasing shape. ![[:Y:]](./images/smilies/smiley20.gif "Thumbs Up") A familiar single-cut mood with a hint of soloist.
|
|
| Author: | Chris Pile [ Sun Jul 10, 2011 10:53 pm ] |
| Post subject: | Re: My First Carved Top |
Off to a good start! |
|
| Author: | Ommadon [ Sun Jul 10, 2011 10:58 pm ] |
| Post subject: | Re: My First Carved Top |
Thanks guys, does anyone have a good way to make the bowl type spots for the control knobs? I used a router cove bit bit in the drill press but was less then impressed. Im open to ideas. |
|
| Author: | Deegatron [ Mon Jul 11, 2011 8:43 am ] |
| Post subject: | Re: My First Carved Top |
Take a drill bit the same size as your holes for the pots.... drill thru a pice of 1" diameter wood rod.... glue the rod to the drill bit.... about 1/2 way up.... once glue is dry put the drill bit into the drill press and spin it.... use a rasp or sand paper on a block to shape the wood rod to any shape you'd like. then glue small strips of sandpaper to the wood block... works like a charm and it's cheep... it'll really only cost you a drill bit..... + you can shape it any way you'd like... from a very soft U to a hard V with a flat on the bottom... anything goes.... |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|