| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| My first maple fretboard... http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10123&t=35512 |
Page 1 of 1 |
| Author: | Marc Lupien [ Fri Feb 24, 2012 7:52 pm ] |
| Post subject: | My first maple fretboard... |
I am making my first maple fretboard guitar. Understandably, I want to apply finish on it! I use polyurethane finishes. I usually fret my boards after they are finished and buffed. How do I approach this? Thanks!!! |
|
| Author: | Mike Dotson [ Sat Feb 25, 2012 12:01 pm ] |
| Post subject: | Re: My first maple fretboard... |
Fret it first, then scrape the frets afterwards. |
|
| Author: | Chris Pile [ Sat Feb 25, 2012 12:46 pm ] |
| Post subject: | Re: My first maple fretboard... |
I've done it both ways. I like finishing it after fretting better. |
|
| Author: | Marc Lupien [ Sat Feb 25, 2012 6:45 pm ] |
| Post subject: | Re: My first maple fretboard... |
Can I ask you why Chris? |
|
| Author: | Chris Pile [ Sat Feb 25, 2012 11:52 pm ] |
| Post subject: | Re: My first maple fretboard... |
Sometimes the lacquer chipped when fretting afterwards. It was just easier to scrape a little lacquer from the fret tops every few coats. Had to do a fret level anyway on refrets or new builds, easy enough to handle the finish then. |
|
| Author: | Marc Lupien [ Sun Feb 26, 2012 6:39 pm ] |
| Post subject: | Re: My first maple fretboard... |
Thank's Chris! |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|