| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Stewmac Martin-style truss rod installation http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10123&t=39225 |
Page 1 of 1 |
| Author: | dzsmith [ Mon Feb 04, 2013 8:47 pm ] |
| Post subject: | Stewmac Martin-style truss rod installation |
Hi, I am preparing to glue in a Stewmac Martin-style truss rod. The instructions say to run a bead of epoxy on the bottom of the sides. Can anyone clarify this? Does the flat part facing the fretboard need to be flush with the fretboard? I've got about 1/32" clearance. Thanks, Dan |
|
| Author: | Mike Dotson [ Tue Feb 05, 2013 2:32 pm ] |
| Post subject: | Re: Stewmac Martin-style truss rod installation |
Yep, epoxy it and yep again, flush is best but you can add a thin veneer if you need to. |
|
| Author: | dzsmith [ Tue Feb 05, 2013 6:34 pm ] |
| Post subject: | Re: Stewmac Martin-style truss rod installation |
Mike Dotson wrote: Yep, epoxy it and yep again, flush is best but you can add a thin veneer if you need to. Thanks Mike, Dan |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|