| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Making a degree milling-table :-) http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10123&t=45781 |
Page 1 of 1 |
| Author: | drklister [ Mon May 25, 2015 2:24 am ] |
| Post subject: | Making a degree milling-table :-) |
Any idees? carl runström |
|
| Author: | arie [ Thu Jun 18, 2015 3:13 pm ] |
| Post subject: | Re: Making a degree milling-table :-) |
why not use a rotary table? |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|