Sandywood wrote:
Awww...the excitement of a new build. Nothing else like it.
An Ash neck got my attention. Maybe nothing new except under my rock. I don't get out much.
Looking forward to seeing more of it and looks like a great start.
I've made quite a few of them and thought I'd share the one I built for myself.
I wound the P-90's and went with a blender rather than a switch.
I screwed up sizing the tuner holes- for the http://www.schaller-electronic.com/hp514510/Schaller-introduces-Da-Vinci.htmso a couple aren't as smooth as they should be...(drill press bad- block under head got chips under it while drilling so a couple of holes were a little slanted)..a set sure worked out good on a different build...I think they look cool too. Over priced though.
I did remove some body wood but it still turned out heavy...a little over 9lbs.
An Ash neck got my attention. Maybe nothing new except under my rock. I don't get out much.
Looking forward to seeing more of it and looks like a great start.
I've made quite a few of them and thought I'd share the one I built for myself.
I wound the P-90's and went with a blender rather than a switch.
I screwed up sizing the tuner holes- for the http://www.schaller-electronic.com/hp514510/Schaller-introduces-Da-Vinci.htmso a couple aren't as smooth as they should be...(drill press bad- block under head got chips under it while drilling so a couple of holes were a little slanted)..a set sure worked out good on a different build...I think they look cool too. Over priced though.
I did remove some body wood but it still turned out heavy...a little over 9lbs.
