I want one
Looking great David!
| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| New bodies getting close to assembly http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10123&t=52115 |
Page 1 of 1 |
| Author: | dofthesea [ Sun Jun 30, 2019 9:13 pm ] |
| Post subject: | New bodies getting close to assembly |
Walnut nd curly maple almost finish just need to sand and buff. |
|
| Author: | Hesh [ Mon Jul 01, 2019 4:07 am ] |
| Post subject: | Re: New bodies getting close to assembly |
I want one Looking great David! |
|
| Author: | B. Howard [ Mon Jul 01, 2019 6:24 am ] |
| Post subject: | Re: New bodies getting close to assembly |
What are you using for finish? Do you always finish drilling for hardware after the finish? |
|
| Author: | dofthesea [ Mon Jul 01, 2019 9:26 am ] |
| Post subject: | Re: New bodies getting close to assembly |
Brian the finish is lacquer. Im still figuring out the sequence of things with finish. What might be your preference? Typically I like the drill out for pots and bridge but Zi wanted to try something different and I got too excited to see this walnut under finish so forged ahead without drilling. Sometimes my add gets the best of me lol |
|
| Author: | Barry Daniels [ Mon Jul 01, 2019 10:30 am ] |
| Post subject: | Re: New bodies getting close to assembly |
Did you do any level sanding between coats? |
|
| Author: | dofthesea [ Mon Jul 01, 2019 10:37 am ] |
| Post subject: | Re: New bodies getting close to assembly |
Barry Yes I level sanded with 300 grit between coats. Hesh I'll trade a finished body for more luthier classes. |
|
| Author: | Barry Daniels [ Mon Jul 01, 2019 2:01 pm ] |
| Post subject: | Re: New bodies getting close to assembly |
You might want to dial down the air pressure because you are getting considerable orange peel. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|