Patrick,
I mixed Padauk and Maple with no problems.
I did not do anything other than sand and finish.
Perhaps the Maples pores were too small to get Padauk dust in them.
Sent from my iPad using Tapatalk
| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Fretboard Markers http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10123&t=55569 |
Page 1 of 1 |
| Author: | PatrickW [ Fri Mar 10, 2023 3:59 pm ] |
| Post subject: | Fretboard Markers |
The telecaster I am building has a maple fretboard, the body is Padauk. I am going to use Padauk markers for the fretboard and wanted to know the best way to prepare the maple so that I don’t impregnate the board with Padauk dust. I plan to use a sanding sealer to seal the maple. This is the first maple fretboard I have done. I appreciate any feedback from those that have done something similar. Thanks, Patrick |
|
| Author: | dzsmith [ Fri Mar 10, 2023 9:07 pm ] |
| Post subject: | Re: Fretboard Markers |
Patrick, I mixed Padauk and Maple with no problems. I did not do anything other than sand and finish. Perhaps the Maples pores were too small to get Padauk dust in them. Sent from my iPad using Tapatalk |
|
| Author: | PatrickW [ Sat Mar 11, 2023 1:19 am ] |
| Post subject: | Re: Fretboard Markers |
Thanks Dan, nice looking Flying V! |
|
| Author: | joshnothing [ Sun Mar 12, 2023 5:58 am ] |
| Post subject: | Re: Fretboard Markers |
I’ve made several padauk guitars with maple binding, end grafts and so on. Straight grained maple has few issues and any dust that it picks up is easily cleaned with naphtha. If there’s curl the runout of the curl can suck up colour in some cases. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|