Official Luthiers Forum!
http://w-ww.luthiersforum.com/forum/

Top, Back, and Sides thickness on a Ukulele
http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10128&t=45046		 Page 1 of 1
Author:  Kent Wilkinson [ Mon Feb 02, 2015 12:29 am ]
Post subject:  Top, Back, and Sides thickness on a Ukulele
How thick should I thickness Top, Back, and Sides on a Ukulele?
Author:  unkabob [ Mon Feb 02, 2015 11:03 pm ]
Post subject:  Re: Top, Back, and Sides thickness on a Ukulele
My rule of thumb used to be 0.070" for back and sides and for the soundboard if it is mahogany. Spruce would be a tad thicker (maybe 0.080").
Recently I have thickened my sides to 0.080".

What plans are you using?

Good luck

Bob :ugeek:
Author:  dofthesea [ Tue Feb 03, 2015 12:02 am ]
Post subject:  Re: Top, Back, and Sides thickness on a Ukulele
The top/back and sides varies quite a bit depending on which species your using.
Author:  Kent Wilkinson [ Thu Feb 05, 2015 10:43 pm ]
Post subject:  Re: Top, Back, and Sides thickness on a Ukulele
I have some Black acacia, maple and Zebrawood. I already have most the body done on a zebra wood concert uke. I took it down to .078 going by how it felt when slightly flexing it. I have some engleman spruce I am planning for the top. Its 3/16 now. I haven't thicknessed it yet.
Author:  Quine [ Fri Feb 06, 2015 12:21 pm ]
Post subject:  Re: Top, Back, and Sides thickness on a Ukulele
For a concert size I'd go closer to 0.07" for the sides for bending. The back is fine at 0.078.
For a typical 2-fan brace concert top in spruce, I'd aim for 0.08".
Author:  unkabob [ Fri Feb 06, 2015 10:37 pm ]
Post subject:  Re: Top, Back, and Sides thickness on a Ukulele
+1 on what Quine says.

Bob :ugeek:
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/