| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| How thin is too thin on uke Headstock? http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10128&t=47453 |
Page 1 of 1 |
| Author: | ADK_Frank [ Tue Mar 15, 2016 1:19 pm ] |
| Post subject: | How thin is too thin on uke Headstock? |
I cut it a little too thin. I'm using grover short post tuners. Will this still hold up or should I add a thin piece to add thickness? |
|
| Author: | profchris [ Tue Mar 15, 2016 4:33 pm ] |
| Post subject: | Re: How thin is too thin on uke Headstock? |
Structurally you're fine. So if the tuners fit, go for it. If you don't like the look, or need more thickness for the tuners, add a headplate. |
|
| Author: | dofthesea [ Sun Mar 27, 2016 10:49 pm ] |
| Post subject: | Re: How thin is too thin on uke Headstock? |
A headstock overlay is always an easy fix. |
|
| Author: | johnparchem [ Sun Mar 27, 2016 11:07 pm ] |
| Post subject: | Re: How thin is too thin on uke Headstock? |
Or if you are still too thin a back strap veneer! That is what I had to do when I slipped in a drum sander. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|