Official Luthiers Forum!
http://w-ww.luthiersforum.com/forum/

Nils' Build
http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10130&t=31378		 Page 1 of 1
Author:  Nils [ Fri Mar 04, 2011 11:52 pm ]
Post subject:  Nils' Build
Hey, this is a build I've been working on for a bit. A couple pics of my mandolins slipped in too.

Image
I also bend with a heated pipe, but I like to get the rough shape first like this.

Image
I joined the top with a router and a straight edge.
Image
Image
I cut circles and route some rosette channels on my routing table.
Image
Image
Balls, didnt go deep enough : (
look at about 4 o'clock
Image
Image
Image
Image
Image
Image
Mando I've been slowly working at
Image
Image
Image
Image
Image
Image
And what a mess....

Thanks for looking. I'll post back when done if you guys would like.
Nils
Author:  DennisK [ Sat Mar 05, 2011 1:49 pm ]
Post subject:  Re: Nils' Build
Lookin' good!

I like your headstock shape.

And that's one honker of a tail block! Any particular reason to make it that thick?
Author:  Nils [ Sat Mar 05, 2011 5:03 pm ]
Post subject:  Re: Nils' Build
I think its just the angle if the picture. Both blocks are one inch thick, and the tail block is just a tad taller than the heel block.
Author:  oval soundhole [ Tue Mar 08, 2011 3:57 pm ]
Post subject:  Re: Nils' Build
What a cool looking guitar. The square shoulder body reminds me of this larson... Image
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/