Simple fix with a slot head screw driver.
Alex
| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Break angle http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10137&t=50366 |
Page 1 of 1 |
| Author: | Ruby50 [ Mon Feb 26, 2018 8:55 pm ] |
| Post subject: | Break angle |
A friend paid $75 for a Global D-body guitar about 3 years ago (with case). She asked that I take a look at this evening. Never seen such a break angle |
|
| Author: | Alex Kleon [ Mon Feb 26, 2018 11:00 pm ] |
| Post subject: | Re: Break angle |
Simple fix with a slot head screw driver. Alex |
|
| Author: | Bill Braske [ Mon Mar 05, 2018 8:58 pm ] |
| Post subject: | Re: Break angle |
It looks like it needs a neck reset. Assuming it's not worth it, I'd hog off about 1/8" of the top of that bridge with a scraper. Then replace the saddle with a big ol hunk o bone, or (more appropriately) fill the saddle slot and re-cut it for a nice bone saddle. Cutting the bridge down won't help the tone any, but a good saddle might. I'm gonna take a wild guess it was never a Martin-killer anyway though. Reading back over your post, I see you weren't asking for advice, so I hope I haven't over stepped. |
|
| Author: | Mark Mc [ Sat Mar 10, 2018 6:35 pm ] |
| Post subject: | Re: Break angle |
Ruby50 wrote: A friend paid $75 for a Global D-body guitar about 3 years ago (with case). Well, if it is a nice case that might have been a good deal. But the guitar doesn't seem to have much of a future. Is the bridge lifting a bit too (the shadow at the bass wing end seems to suggest it, but might be an illusion)? We are presuming that the action is high despite the zero-height saddle? |
|
| Author: | phavriluk [ Sat Mar 10, 2018 10:23 pm ] |
| Post subject: | photo perspective |
I get the impression that the rear of the bridge, region of the pins, is either level with the front, or even higher than the front. If so, thinning that region may be possible, and in so doing, causing more of a break angle. Wouldn't cost but the tools to do it and the masking tape to protect from damage. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|