| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| Interesting NEWneck removal process http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10137&t=50548 |
Page 1 of 1 |
| Author: | Ben-Had [ Sun Apr 22, 2018 8:53 am ] |
| Post subject: | Interesting NEWneck removal process |
Why didn't anyone thik of this before? http://www.stewmac.com/How-To/Tool_Demo ... B_20180422 |
|
| Author: | Chris Pile [ Sun Apr 22, 2018 1:06 pm ] |
| Post subject: | Re: Interesting NEWneck removal process |
Dang. That worked well. Wonder what it would do with epoxied joints I've run into.... |
|
| Author: | DanKirkland [ Sun Apr 22, 2018 1:44 pm ] |
| Post subject: | Re: Interesting NEWneck removal process |
There was a guy a while back that was experimenting with removing a neck with two small rods that were connected to a heating source much like a battery. I think Frank Ford helped him figure it out. I'll see if I can find the video. This is a good idea, the only drawback I see is having to drill the second hole to #27 size. That's a big piece of fingerboard to patch/cover up once the job is complete. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|