| Official Luthiers Forum! http://w-ww.luthiersforum.com/forum/ |
|
| KMS CA Remover http://w-ww.luthiersforum.com/forum/viewtopic.php?f=10137&t=54842 |
Page 1 of 1 |
| Author: | Conor_Searl [ Fri Mar 18, 2022 3:57 pm ] |
| Post subject: | KMS CA Remover |
Anyone ever use this stuff? Would it be safe for guitar finishes? I'm very skeptical... |
|
| Author: | Barry Daniels [ Fri Mar 18, 2022 4:41 pm ] |
| Post subject: | Re: KMS CA Remover |
It's most likely acetone so it would not be safe on finishes. |
|
| Author: | Tim Mullin [ Fri Mar 18, 2022 5:08 pm ] |
| Post subject: | Re: KMS CA Remover |
This is likely nitromethane, used also as fuel for radio-controlled aircraft/vehicles. It is even more agressive than acetone, so keep it away from finishes. Sent from my iPad using Tapatalk |
|
| Author: | Hesh [ Fri Mar 18, 2022 7:11 pm ] |
| Post subject: | Re: KMS CA Remover |
I think that this is made by Bob Smith and then private labeled and yes I've used it for RC aircraft but never guitars. I would avoid finishes with it too since it can melt CA off. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|