Runout on a Drill Press Quill

Board index » Forum Archive

All times are UTC - 5 hours

Runout on a Drill Press Quill

Page 1 of 1

[ 2 posts ]

Print view

Previous topic | Next topic

Author

Message

Brock Poling

Post subject:

Posted: Sat Jan 08, 2005 6:19 am

Old Growth Brazilian Rosewood

Joined: Mon Dec 27, 2004 1:20 pm
Posts: 5915
Location: United States

Is there any way to fix the run out on a drill press quill. My Delta 350 works fine for bits, but when I chuck up a robo sander or anything like that I get too much wobble.

Thoughts?

_________________
Brock Poling
Columbus, Ohio
http://www.polingguitars.com

Top

JJ Donohue

Post subject:

Posted: Sat Jan 08, 2005 6:39 am

Brazilian Rosewood

Joined: Mon Dec 27, 2004 3:50 pm
Posts: 4662
Location: Napa, CA

Brock...I have the same drill press. I purchased a drum sanding system from Lee Valley that uses a bearing disc into which the bottom of the drum is captured. http://www.leevalley.com/wood/page.asp?page=20202&category=1 ,42500&ccurrency=2&SID= It rotates without any runout whatsoever. You might use something similar with the Robo-Sander.

_________________
JJ
Napa, CA
http://www.DonohueGuitars.com

Top

Page 1 of 1

[ 2 posts ]

Board index » Forum Archive

All times are UTC - 5 hours

Who is online

Users browsing this forum: No registered users and 50 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:

Official Luthiers Forum!

Runout on a Drill Press Quill

Who is online